TECNOTANK

TECNOTANK

TECNOTANK spiral tank

More than any other tank manufacturer, we are connecting efficiency to sustainability and design

Technological advantages

  • The spiral shape similar to a spring gives the tank the best elasticity against seismic stresses

  • The absence of welding crossings and consequent stresses (with the same resistance) allows for an improvement in thickness and better heat exchange, allows the use of less cold fluids with consequent energy savings

  • The arrangement of the exchange pockets on the plating allows to always have contact in the right measure and a partial use of the tank

  • The leveling of all the cylinder welds by cold rolling and the perfect shape of the plating allow washing and sanitizing with less use of water and sanitizers

100% “MADE IN ITALY” design, innovative and attractive

TECNOGEN uses a pocket technology that does not deform the internal part of the tank and is very effective (constant section, turbulence, large section of passage of the cooling fluid, greater efficiency) while the competitors use a technology that deforms the tank plates and it has an uncontrollable and minor section. There is therefore less heat exchange and the creation of areas that are difficult to clean

TECNOTANK, the technology that guarantees fully automatic and perfect assembly

1

Constant alignment of the spiral plating CLASS 1 SEAM STRENGTH.

+ RESISTANCE WITH EQUAL THICKNESS

2

Continuous inner surface without dead zones

EASIER, MORE ECONOMICAL AND AUTOMATABLE CLEANING

3

Frequent misalignment in the overlapping of the rings that make up the plating

REDUCTION OF THE RESISTANT THICKNESS

4

internal ridges

HARD-TO-CLEAN AREAS

formation of sludge which is difficult to remove

+20% resistance to pressure

for the same thickness

+40% structural strength

for the same thickness (according to international VSR standards)

+40% energy saving

due to optimised heat exchange and improved distribution of the spiralled jackets on the ferrule

No hard-to-clean ridges

 on the inside of the tank caused by differing thicknesses or imperfect assembly of metal sheets

Simplified cleaning

thanks to the quality of the joints in the tank, allowing up to 2/3 of time and water to be saved

The exclusive patented system guarantees

 a level of quality that cannot be matched if not with much higher costs

INFO

Scrivici ti ricontatteremo al più presto

PHONE

+39 0461 538330

PHONE

+39 0461 538322

EMAIL

info@tecno-gen.it

PHONE

+39 0461 538330

PHONE

+39 0461 538322

EMAIL

info@tecno-gen.it